Milwaukee Gen2 FUEL Impact Driver review – 2753

oztooltalk review of this little beast. we really like it.

Error keeps popping up I’ll check it out on it ur in a bit.

Great video dwain

Sent from my iPhone using Tapatalk

Great video, do you think if given time it would reach listed torque on mode 3?

Sent from my iPhone using Tapatalk

Great video OTT!!

thanks all

DarynH wrote:

Great video, do you think if given time it would reach listed torque on mode 3?

i don’t think so. id like to test other drivers to figure out if they would have the same issue…

dwain wrote:

thanks all

 

 

i don’t think so. id like to test other drivers to figure out if they would have the same issue…

Have you tried tightening a nut to 200Nm with that torque wrench then seeing what torque it says is required to loosen the nut with the torque wrench?

great video dwain as always. Thank you!

great video..     then impact…. ehh     haha    still glad im in the Makita battery! no jealously causing stuff here compared with the dtd148/xdt09 Makita      it really is a nice impact though and great for anyone on team red

Great video Dwain! Not going to change my brands but looks like a sweet impact driver!

jeffmcmillan wrote:

Have you tried tightening a nut to 200Nm with that torque wrench then seeing what torque it says is required to loosen the nut with the torque wrench?

that’s a really good point jeff, i should have thought of that. I’ll check it soon.