Archived from the Tools In Action forum (Milwaukee). This thread is read-only.
I have the gen 2 impact and hammer combo, and loving them so far. Do they make a bit holder attachment to screw on the side like my Dewalts have? I’m constantly switch between between Phillips and 5/16, would be nice to keep it close by.
sgand2010 wrote:
13 hours ago, sgand2010 said:I have the gen 2 impact and hammer combo, and loving them so far. Do they make a bit holder attachment to screw on the side like my Dewalts have? I’m constantly switch between between Phillips and 5/16, would be nice to keep it close by.
Nope. What I did was modify a magnetic 1/4″ square to 1/4″ hex and screwed it to the belt clip nut. I also ground the underside so it grips the overmold and limits it’s want to spin when bumped.
Here’s the socket: https://www.amazon.com/gp/product/B0040UBLO0/
[External image (i.imgur.com), not copied]
[External image (i.imgur.com), not copied]
[External image (i.imgur.com), not copied]
BMack37 wrote:
17 hours ago, BMack37 said:
Nope. What I did was modify a magnetic 1/4″ square to 1/4″ hex and screwed it to the belt clip nut. I also ground the underside so it grips the overmold and limits it’s want to spin when bumped.
Here’s the socket: https://www.amazon.com/gp/product/B0040UBLO0/
[External image (i.imgur.com), not copied]
[External image (i.imgur.com), not copied]
nice job
I just super glue tiny rare earth magnets from Harbor Freight on to the side and they hold bits just fine.