LS1019L

I’ve just purchased the new LS1019L compound mitre saw, and was going through the setup yesterday in my front room. The mitre works fine both ways . It beveled fine to the left but I unscrewed the new front release and pressed the release button at rear to bevel right and it’s got to 22.5 degrees and locked in position and I can’t get it to release, I’ve tried unscrewing the front release more, rocking it abit while pressing the rear release button and nothing works.

help !!

which release button are you using? the one on the left is to unlock it to bevel to the right, theres a lever on the right side that is used to unlock while beveled, its a little awkward to to use but requires a good yank on it