Diamond Edge Cut Off Wheels

Enjoy this was a fun one

hey, jimbo I found ya dude!!

http://www.coptool.com/diamond-edge-cutting-wheels-head-head/

KnarlyCarl wrote:

hey, jimbo I found ya dude!!
 
http://www.coptool.com/diamond-edge-cutting-wheels-head-head/
 
 
 

JimboS1ice wrote:

On 8/19/2017 at 7:11 AM, JimboS1ice said:

Thanks guy I was meaning to post the link they were interested in my comparison so I did a write up for them, same article is on my site as well emoji1360.pngemoji1363.png


Sent from my iPhone using Tapatalk

You have a website?

hahaa just messing…. way too much going on trying to be everywhere at once so i just speed read through the one at coptool lol

So far the Diablo is meh…. I believe if someone was looking for a smooth cutting wheel for finer stuff, it would work great. I also suspect it would work well in thinner sheet metal where you want to keep burrs down. But for my use, i need something more aggressive. So that’s why I’ll keep using my Ridgid one. I think i’ll skip the Milwaukee and try and get the Lenox though…

KnarlyCarl wrote:

You have a website?
hahaa just messing…. way too much going on trying to be everywhere at once so i just speed read through the one at coptool lol
 
So far the Diablo is meh…. I believe if someone was looking for a smooth cutting wheel for finer stuff, it would work great. I also suspect it would work well in thinner sheet metal where you want to keep burrs down. But for my use, i need something more aggressive. So that’s why I’ll keep using my Ridgid one. I think i’ll skip the Milwaukee and try and get the Lenox though…

Love the rigid but when it gets dull I might get the lenox . Ive probably made 65 ish cuts with the rigid fast cutting but with thicker stuff doesnt work the thickest ive cut is 1/4 .Here’s a couple pictures of brass I cut did a lot better then I though . The brass is 1/2 thick for about half of it . Also a little late but loved the comparison video jimbo did a great job man 👍👍👍