Handle for M18 grinder ?

Does anyone know where I could get a handle for my M18 grinder ?

They are all standard grinder handles. They probably sell them at HD. I bet you could get one from just about any tool owner. I think all of my handles (except for my hammerdrill) have ended up getting tossed.

I recall the standard being an M8 thread so you can get any grinder handle or even that size bolt.  A bent piece of conduit can bolt on as a ghetto loop handle for surface grinding.

See it listed here for $7.92, plus whatever they get for shipping. It’s Milwaukee 42-62-0125.

http://www.ereplacementparts.com/milwaukee-278120-m18-fuel-angle-grinder-with-slide-switch-and-lockon-parts-c-131_4779_417854.html

$7.19 here, plus $8.00 shipping.

http://www.toolpartsdirect.com/milwaukee-42-62-0125-avs-side-handle.html

Just grabbed one off eBay – thanks guys

What I want is one of those tool-less wheel nuts they have on the new braking grinders.

JerryNY wrote:

32 minutes ago, JerryNY said:

What I want is one of those tool-less wheel nuts they have on the new braking grinders.

I haven’t used my wrench yet, always just hand tight with lock

JerryNY wrote:

1 hour ago, JerryNY said:

What I want is one of those tool-less wheel nuts they have on the new braking grinders.

Haven’t used a wrench in years.  If something’s really stuck on there just tap the blade lock while it’s spinning down and it’ll put way more torque to loosen the blade than you can do with a wrench.  Sometimes it goes flying.  Safety note: This is not safe for you or the grinder.

Yeah gloved hand instead of a spanner has always been my go to.

jeffmcmillan wrote:

Haven’t used a wrench in years.  If something’s really stuck on there just tap the blade lock while it’s spinning down and it’ll put way more torque to loosen the blade than you can do with a wrench.  Sometimes it goes flying.  Safety note: This is not safe for you or the grinder.

Safety note?? Lol that gave me a chuckle

Jimbo

Sent from my iPhone using Tapatalk