HoldRite HydroFlame Pro Telescoping Firestop Sleeve (HFP-P2)

We may earn a commission from links on this page. Affiliate disclosure

HoldRite HydroFlame Pro HFP-P2 telescoping firestop sleeve with a red base and red cap

Stops fires from jumping floors. In our latest Instagram reel we looked at the HoldRite HydroFlame Pro telescoping firestop sleeve, a cast-in-place sleeve that goes into a concrete slab wherever a pipe needs to pass between floors. It comes from SharkBite’s HoldRite brand, and in the clip we call it out as coming from RWC, the same company that brings you SharkBite. The sleeve we pick up in the reel is labeled model HFP-P2. Here is the Instagram reel.

View this post on Instagram

What the Video Shows

The sleeves are set on the deck before the pour, and the concrete goes in around them. When the crew is done, you pull the cap. Inside the sleeve is a material that reacts to heat: as we explain in the reel, if a fire reaches it, it expands into a foam that seals around the pipe, so fire, smoke and water can’t travel up along the pipe to the next floor.

The display also showed sleeves already set in a slab, several sizes and versions of the sleeve, and the adjustable telescoping design, which lets the sleeve be raised or lowered to match the slab. Plumbers and electricians can both use them for the pipe and conduit runs they bring through a floor.

What HoldRite Says About the HFP-P2

On its HydroFlame Pro Telescoping Firestop Sleeve page, HoldRite lists these details:

  • The HFP-P2 is sized for 1-1/4 to 2 in. NPS pipe and is listed for plastic and metal piping
  • A red base and red whiskers identify a plastic or metal piping system; the black-base versions are for metal piping
  • The telescoping design adjusts from 7-1/2 in. to 11-3/4 in. in 1/4 in. increments, can be cut to as short as 2-1/2 in., and extensions are available for slabs over 11-3/4 in.
  • Locator whiskers help find buried sleeves, and the safety caps meet OSHA hole cover requirements
  • Built-in fire, smoke, gas and water protection, with a UL W-rated seal
  • For flat concrete form decks or corrugated metal decks (a corrugated deck plate is required), with insulated or non-insulated pipe
  • Tested to ASTM E814, UL 1479 and CAN/ULC S115; HoldRite says the line has two- or three-hour F-ratings

Across the HydroFlame Pro line, HoldRite lists sizes for 1/2 in. to 6 in. penetrants, including piping, conduit and cables, and says the sleeves can also be used with floor drains, shower drains and closet flanges. For the exact rating on a given job, HoldRite points to its UL system details.

A Look, Not a Hands-On Test

This article covers what we saw in the clip and what HoldRite lists for the product. We have not tested the sleeve ourselves. Firestopping has to match the approved system for the job, so check HoldRite’s documentation and your local code requirements before choosing a sleeve.

Where to Find It

Specs, drawings and install instructions for the HydroFlame Pro telescoping sleeve, including the HFP-P2, are on HoldRite’s product page, which also has a where-to-buy link.

Leave a Reply

Your email address will not be published. Required fields are marked * First-time comments are reviewed before they appear.

Comment on FacebookJoin the conversation on our Facebook page.

You are the influencer. Post it to 4.4 million followers.

Hit record. We’ll handle the rest.

Upload your review