Archived from the Tools In Action forum (Ryobi). This thread is read-only.
Hello,
Update: I managed to the remove the hex but (part #1). Turns out it was a left handed thread 😅. Driven pulley (part #2) still does not come off. Any advice would be appreciated.
Original post: I am trying to remove the “driven pulley” (part #2) however I cannot find a way to stop the pulley from rotating while trying to loosen the “hex nut” at the top (part #1). The Any suggestions or direction toward what is probably going to be a very obviously and in your face solution?
[External image (s3.us-central-1.wasabisys.com), not copied]
Part #2 – driven pulley:
[External image (s3.us-central-1.wasabisys.com), not copied]
Part #1 – Hex nut:
[External image (s3.us-central-1.wasabisys.com), not copied]