Archived from the Tools In Action forum (Ryobi). This thread is read-only.
Hi, I saw this saw on offer at B&Q and it looked a decent product so it came home with me. It’s my first Ryobi tool, but my son has a good stock of them and swears by them,
Out of the box, when et to 0 degrees, a practice cut tested by a T square shows the cut to be around 1 degree short of the expected 90. That’s enough to throw a lot of stuff out of sync.
I’m sure there must be a way of adjusting the thing, but I’m blowed if i can make sense of the poor instructions.
Just wondered if anyone else might be able to help?
Thank you
Mike