Archived from the Tools In Action forum (In The Shop). This thread is read-only.
well while everything else is going on in the shop, moving stuff around setting everything up for new dust collection, I was given an over sized board room table, this table was solid close to 1″ high grade plywood so I figured repurpose it and make a bigger outfeed table here it is finished….Don’t mind the mess tools everywhere and allover where they are not suppose to be….lol never ends….
Very nice Tony. That will be hard not to pile stuff on 🙂
Looks good. What jointer do you have? I’ve been striking out this past week on Craigslist on them.
Sent from my Pixel XL using Tapatalk
thanks it an older Delta 6″ works ok nice and solid straight as a die picked it up for 120 bones off an elderly fellow awhile back, I think it paid for itself 10 times over…..
comp56 wrote:
thanks it an older Delta 6″ works ok nice and solid straight as a die picked it up for 120 bones off an elderly fellow awhile back, I think it paid for itself 10 times over…..
[External image (i274.photobucket.com), not copied]
It looked like a Delta but wasn’t sure. They seem to be at a premium here. [emoji17]
Sent from my Pixel XL using Tapatalk
Nice setup !!
Nice job Comp