View this post on Instagram
Table of Contents
Introduction
When painters use an airless spray gun, the tip is set to spray either a horizontal fan or a vertical fan. Switching between the two usually means stopping and using your other hand to turn the tip.
The Fan Pivot is built to fix that. In our video, the Fan Pivot team showed us how it works, and our caption said it best: the details of the pivot itself are very intriguing.
What It Is
The Fan Pivot is an accessory that goes on an airless spray gun with a 7/8 in. thread. With it on the gun, you reach out with one finger and rotate the tip 90 degrees, from horizontal to vertical and back, without putting the gun down.
The maker lists it for Graco, Wagner, Titan and TriTech guns, with a note that some hand guards may need to be modified to fit.
How It Works
The interesting part is inside. As they explained in the video, there are no springs or ball bearings holding the position. Instead, it uses multi-pole magnets, which are multiple magnetic poles on the same surface. That magnetic detent clicks the tip into position, and according to the maker, it never wears out or changes.
It’s rated up to 3600 psi and made from glass-filled nylon and aluminum. When you clean up, don’t submerge it.
Specs
- Thread: 7/8 in.
- Fits: Graco, Wagner, Titan and TriTech airless guns (some hand guards may need modification)
- Rotation: 90 degrees
- Detent: multi-pole magnets
- Max pressure: 3600 psi
- Materials: glass-filled nylon and aluminum
- Weight: 3.52 oz.
- Model: 100230
Where to Buy
The Fan Pivot is available on Amazon (affiliate, we may earn a commission). Prices change, so check current pricing.
Final Thoughts
It’s a small part, but if you spray all day and switch between horizontal and vertical passes, one-finger switching adds up. The magnetic detent is a smart design, too. For more, see our painting tool reviews.
FAQ
What spray guns does the Fan Pivot fit?
Airless guns with a 7/8 in. thread. The maker lists Graco, Wagner, Titan and TriTech, and notes some hand guards may need modification.
How does the Fan Pivot hold its position?
With multi-pole magnets instead of springs or ball bearings.
How much pressure can it handle?
It’s rated up to 3600 psi.
Can I soak it to clean it?
No. The maker says not to submerge it.
Leave a Reply